Description
The 15 - foot Miller MDX Liner LMD3A - 15 is perfect for .035 to .045 wire. It offers amazing features that enhance your welding experience.
Optimized Wire Feeding
- When you tighten the diffuser, the contact tip aligns and centers with the liner lock, creating a perfect wire - feed path. This reduces burnbacks, bird - nesting, and erratic arcs, making your welding smoother.
Error - Proof Replacement
- You can replace and trim liners accurately every time without measuring! Load and lock the liners from the front of the gun, then lock and trim them flush with the power pin cap at the back. This helps reduce wire - feeding problems caused by improper liner trim lengths.
*Use with .035 - .045 wire sizes
*Compatible with the MDX - 250 MIG Gun
Video
Accessories
Using this Miller AccuLock MDX MIG gun liner is easy. First, make sure you're using it with .035 to .045 wire sizes and it's compatible with the MDX - 250 MIG Gun. When replacing the liner, you don't need to measure. Just load and lock it from the front of the gun, then go to the back and lock and trim it flush with the power pin cap. For optimal performance, always check the alignment of the contact tip with the liner lock by tightening the diffuser. This will keep the wire - feeding smooth. As for maintenance, regularly inspect the liner for any signs of wear or blockage. If you notice any issues, replace the liner right away to avoid problems like burnbacks, bird - nesting, and erratic arcs.
