Description
Optimized Wire Feeding
When you tighten the diffuser, the contact tip aligns perfectly with the liner lock. This creates a smooth wire - feed path, reducing burnbacks, bird - nesting, and uneven arcs. You'll enjoy a more stable welding process.
Error - Proof Replacement
Replacing and trimming liners is a breeze! No need to measure. Just load and lock the liners from the front of the gun, then lock and trim them flush with the power pin cap at the back. This helps avoid wire - feeding problems caused by improper liner trim lengths.
*Use with .030' - .035' wire sizes
*Compatible with the MDX - 250 MIG Gun
Accessories
Using this Miller AccuLock MDX MIG gun liner is easy. First, make sure you're using .030 - .035 wire sizes and that your gun is the MDX - 250 MIG Gun. When tightening the diffuser, you'll notice the great wire - feeding performance. If you need to replace the liner, don't worry about measuring. Load and lock it from the front of the gun, then finish the process at the back. As for maintenance, keep an eye on the wire - feed path to ensure it stays clean. If you start to experience burnbacks or uneven arcs, check the alignment of the contact tip and liner lock. This will help keep your welding experience smooth and efficient.
