Lincoln LN-23P Portable Lightweight Semiauto Wire Feeder - K316L-1

The LN - 23P semiautomatic wire feeder is a top - notch solution for tough work sites, especially great for field erection and pipe welding. It's super portable and a breeze to set up, letting you reach those hard - to - access spots with ease. This feeder uses special 14 lb. (6.35kg) Innershield (FCAW - S) coils that are incredibly lightweight, so you can carry it around the job site without breaking a sweat. It also features a built - in dual wire feed speed switch for out - of - position welding. Comes with a 25 ft. (7.6m) control cable (6 - pin to leads for terminal strip), a 25 ft. (7.6m) 1/0 electrode cable, and 3/32 drive rolls/guide tubes. Advantages of Lincoln LN - 23P: - Weighs under 50 lbs. (22.7 kg) including optional Magnum Innershield gun and 14 lb (6.3 kg) coil of electrode. - Standard continuous wire feed speed control, voltage control, and analog voltmeter. - The fully enclosed wire reel keeps the wire clean from contaminants. - Trigger interlock circuit reduces operator fatigue. - Gun - mounted two - position switch enables on - the - fly change to 83% of the preset wire feed speed. - Electrode and control cable connect quickly to the power source. - One or two LN - 23P wire feeders can connect to recommended Lincoln power sources, but only one can be used at a time. - 3 - year warranty on parts and labor. - Manufactured under an ISO 9001 - certified quality system.

Using the Lincoln LN - 23P wire feeder is quite simple. First, connect the electrode and control cables to the recommended Lincoln power source. It's quick and easy to do. Make sure the fully enclosed wire reel has the 14 lb. Innershield coil properly loaded to keep the wire free from dirt and other contaminants. When you're ready to start welding, use the continuous wire feed speed control and voltage control to set the right parameters. You can use the analog voltmeter to check the voltage. The gun - mounted two - position switch allows you to change the wire feed speed while you're working. For out - of - position welding, use the built - in dual wire feed speed switch. The trigger interlock circuit is there to help reduce your fatigue during long welding sessions. Here are some things to keep in mind. Only one of the LN - 23P wire feeders can be used at a time when connected to the power source. And don't forget that it comes with a 3 - year warranty on parts and labor. For maintenance, regularly check the wire reel for any signs of wear or damage. Keep the feeder clean and dry. If you have any issues, contact Lincoln customer service. They'll be happy to help you out.