Miller MVP Adapter Plugs for 5-15P Cable - 219261

This Miller MVP Adapter Plug operates at 115 Volts and 15 Amps. It's a great replacement multi - voltage plug adapter for your Miller welder or plasma cutter with a 4 - pin multi - voltage input power cord. It fits standard household NEMA 5 - 15 receptacles. Compatible with various Miller models like Millermatic 211, Millermatic DVI, Millermatic Passport Plus, Multimatic 200, Multimatic 215, Miller Maxstar 150 series TIG/Stick welders, and Miller Spectrum 375 X - TREME.

Using the Miller MVP Adapter Plug is easy. First, make sure your Miller welder or plasma cutter is turned off. Then, connect the adapter plug to the 4 - pin multi - voltage input power cord of your device. Next, plug the adapter into a standard household NEMA 5 - 15 receptacle. When using, always check that the voltage and amperage match your device's requirements. For maintenance, keep the plug clean and dry. Avoid pulling on the cord to remove the plug. If you notice any damage to the plug or cord, stop using it immediately and replace it to ensure safety.