The Magswitch 90 Degree Angle 165 is a top - notch welding tool. It has two MagSquare magnets. Each magnet can hold 165lb on 1/4 - inch steel on every axis, whether it's flat or round steel. These magnets can move up and down and be reversed on each axis. You can add more MagSquare for extra strength. It's an 8 - inch welding angle with two 165 - lb breakaway capacity magnets. Different from other brands, when the Magswitch is off, debris can fall away easily. It offers fast and easy on/off magnet control, holds flat materials and pipes, and has a non - marring hold. There's a locking knob for safety. You can add more Magswitches to increase strength. It's versatile with pre - tapped holes to change the Magswitch position for inside or outside angles. Just turn the Magswitch knob 180 degrees to activate or deactivate it, and the holding force increases gradually as you turn, allowing for precise positioning.
Using the Magswitch 90 Degree Angle 165 is simple. First, decide where you want to use it for welding. Place it on the flat or round steel surface. To activate the magnet, turn the Magswitch knob 180 degrees. As you turn, you'll feel the holding force gradually increasing, which helps you position it exactly where you need it. You can add more MagSquare or Magswitches to make the hold stronger if you're working on a bigger or heavier project. When you're done, turn the knob back 180 degrees to deactivate it. One great thing is that when it's off, any debris on it will fall away easily. For safety, always make sure the locking knob is in place. As for maintenance, keep it clean. Wipe it down after each use to prevent any dirt or debris from getting stuck in the moving parts. Store it in a dry place to avoid rusting. That's all you need to know to use and take care of this handy tool.
