Miller Optional Drive Roll for .023 Wire - 199731

Enhance your welding experience with the Miller V - Knurl Drive Roll. Specifically designed for Spoolmate 100, 185, and 3035 MIG guns, it's perfect for .023 - inch solid or flux - cored welding wire.

Using this Miller drive roll is easy. First, make sure your MIG gun (Spoolmate 100, 185, or 3035) is turned off. Then, install the drive roll according to the gun's instructions. When you're welding, use .023 - inch solid or flux - cored wire as recommended. For maintenance, keep the drive roll clean and free from debris. After each use, wipe it down with a clean cloth. If you notice any signs of wear, it might be time to replace it. Always follow safety guidelines when using welding equipment.