This is a high - quality replacement rear strain relief. It's specifically designed for use with MDX™ - 100 and MDX™ - 250 MIG guns, ensuring a reliable connection and smooth operation.
Using this Miller rear strain relief is easy. First, turn off your MDX - 100 or MDX - 250 MIG gun and disconnect it from the power source. Then, remove the old strain relief and replace it with this new one. Make sure it's securely attached. When using your MIG gun, avoid pulling or tugging on the cable too hard as it may damage the strain relief. For maintenance, keep it clean and dry. If you notice any signs of wear or damage, replace it promptly to ensure safe and efficient operation.
