Description
The Miller AccuLock MDX LM1A-10 liner, at 10 feet long and designed for .023-.030 wire, offers excellent feed ability and makes liner changes a breeze.
Optimized Wire Feeding
- When you tighten the diffuser, the contact tip aligns and centers with the liner lock, creating a perfect wire-feed path. This reduces burnbacks, bird-nesting, and uneven arcs.
Error-Proof Replacement
- Replace and trim liners accurately every time without any measuring! Load and lock the liners from the front of the gun, then lock and trim them flush with the power pin cap at the back. This helps reduce wire-feeding issues caused by improper liner trim lengths.
*Use with .023 - .030 wire sizes
Accessories
Using the Miller AccuLock MDX LM1A-10 liner is straightforward. First, make sure you're using wire sized between .023 and .030. When you need to replace the liner, you can load and lock it from the front of the gun. Then, lock and trim it flush with the power pin cap at the back - no need to measure. This way, you can avoid wire - feeding problems due to incorrect trim lengths. To maintain good wire - feeding performance, always ensure the diffuser is tightened properly so that the contact tip aligns with the liner lock. This alignment creates a smooth wire - feed path and reduces issues like burnbacks and bird - nesting. Also, regularly check the liner for any signs of wear and tear. If you notice any damage, replace it right away to keep your MIG gun working well.
